A good elevator waiting time is one that meets the building’s agreed service targets under the traffic conditions people actually experience. There is no single number that proves every office, hotel or mixed-use building has good lift service.
To judge performance, look at average waits, unusually long waits, passengers left behind and the time needed to reach a destination. This guide explains how to measure those experiences and use the results when reviewing equipment or an upgrade.
Waiting time vs interval
These terms describe different things and should not be used interchangeably.
Interval is the average time between lift departures from the main lobby in a defined traffic scenario. In a simple conventional up-peak calculation, it is derived from the round-trip time and the number of lifts in the group.
Waiting time measures a passenger’s wait for service. Define precisely when the measurement starts and ends, particularly where passengers join an existing queue or use destination-control terminals. A controller’s recorded hall-call response may not represent every person’s wait.
Average waiting time cannot reliably be obtained by applying a fixed percentage to the interval in every building. Queues, car loading, arrival patterns and dispatching all affect the relationship.
Setting targets by building type
Agree targets with the client and lift consultant before comparing proposals. State both the expected demand and the result being measured. A target for a quiet period is not evidence of acceptable performance during the morning peak.
| Building type | What a useful assessment should include |
|---|---|
| Office | Morning arrival, lunch and departure peaks; average and long waits; the effect of occupancy changes. |
| Hotel | Check-in, checkout and event demand; luggage and boarding time; separation of guest and service movement. |
| Mixed-use commercial building | Different user groups, entrances and access restrictions; transfers and demand from shared facilities. |
Illustrative example: two buildings might both report a 20-second average. In one, waits stay close to that figure. In the other, a minority of passengers repeatedly wait several minutes because cars arrive full. The identical average hides a different service problem. The example is not a recommended 20-second benchmark.
A useful specification therefore includes a measure of long waits, such as an agreed percentile, alongside the average. The consultant should identify the relevant planning method and explain how the proposed criteria suit the building.
How to check your building
- Observe representative busy periods across more than one day, including morning and lunchtime where relevant.
- Record individual passenger or group waits using a consistent start and end definition.
- Note queues, full cars, missed boarding opportunities, service deliveries and lifts out of operation.
- Separate results by traffic period rather than hiding peaks in an all-day average.
- Compare observations with any available controller records, checking what those records actually measure.
A small spot check can reveal a problem, but it should not be presented as a complete performance assessment. Use a sample and observation plan appropriate to the building’s variability.
How to reduce waiting times
Start with operation and maintenance
Investigate lifts that are frequently unavailable, door faults and recurring service interruptions. Review the timing of deliveries or housekeeping trips where these compete with passenger demand.
Ask a qualified lift specialist to assess parking strategies, dispatching and door settings. Changes must preserve accessibility, safe boarding and the approved operating requirements; simply shortening door-open time can create new problems.
Assess modernization against measured demand
Control upgrades, zoning changes or different operating arrangements may improve service, depending on the cause of the delay. A higher rated speed alone may have limited benefit where most time is spent boarding, opening doors or making frequent stops.
For a larger shortfall, a building traffic study can compare modernization with more substantial changes. When reviewing FUJI elevator options, ask how the proposed equipment relates to the study’s assumptions and service targets.
Common mistakes
- Reporting the design interval as actual passenger waiting time.
- Measuring only quiet periods.
- Using an average without examining the longest waits and passengers left behind.
- Assuming a faster drive automatically solves a capacity or dispatching problem.
- Keeping the original traffic assumptions after occupancy or floor use changes.
Turning measurements into a decision
Define the service you need, measure the busiest conditions and identify the cause of poor performance before choosing an upgrade. Supplier comparisons are more useful when every proposal is tested against the same population, traffic patterns and performance criteria.
Contact FUJIHD with the building use, lift arrangement and available traffic-study findings to discuss the equipment requirements for your project.
